ISE SY-T2708 Manuel D'utilisateur page 38

BUTTON
（1）
（2）
（3）
（4）
（5）
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the
power switch located at the front of the treadmill below the motor shield. Ensure that the
safety key is installed, as the treadmill will not power on without it. When the power is
turned on, the display is ready for operation.
Press and release the START / STOP to begin belt movement, at 1.0 km/ h, then use"+"
or"-" to adjust to the desired speed. You can also use the "+" or "-" on the remote control
to adjust the speed
• To slow the treadmill down , press and hold the "speed-" key to desired speed.You can
also press the "-" key on the remote control to adjust to the speed you need
• In a state of running, single press START/STOP, the walking belt will gradually slow down.
• In the state of running, single press CLEAR/SET will reset time, distance, calorie.
CALORIE WEERGAVE
Displays the cumulative calories burned at any given time during your workout.
REMOTE CONTROL
Turn on the machine, press the button to choose the preset programs P1-P15.
Turn on the machine, press the button to start walking. While walking, press the
button to stop and register walking. Press CLEAR/ SET to clear the registration.
When the treadmill is in standby mode, press this button to put the
In sleep mode, press any button to wake up the treadmill and put it
While walking, press the button to increase the speed by 0.5 km/ h. Hold the
button to increase speed continuously.
While walking, press the button to decrease the speed by 0.5 km / h. Hold the
button to decrease the speed continuously.
FUNCTION DESCRIPTION
FUNKTION
Press CLEAR/ SET to exit.
treadmill into sleep mode
into standby mode
14
EN