Publicité
Les langues disponibles
Les langues disponibles
• We suggest that you should cut off the power for 10 minutes after keep running 2 hours,
so that it's good for maintain the treadmill.
• For avoiding the slipping during running, the belt not too loose; for avoiding the more
abrasion between the roller and belt and maintain the machine's good running ,the belt not
too tight. You can adjust the distance between plates and belt, the belt be away from the
plates about 50-75 mm on both sides, if the best not too tight and loose.
We strongly recommend that you do the following
• Switch off and remove the power cable from the wall after every use, especially if chil-
dren are present.
• Clean your treadmill after use.
• Use a dry cloth to clean the control panel and areas around the power switch. Use a soft
clean cloth and cleanser to remove stubborn stains and dirt off the running belt.
• Tighten the running belt once a month.
• Keep your treadmill in a safe dry place away from heat and water.
USAGE OF SILICONE OIL
Pull up tightly of the running belt. Then put the
silicone oil to running board. Then start the machine
to running 3 minutes without loading. It is better
to maintain like this every 30 hours working of the
EN
machine. This can save lifetime of parts properly.
We recommend that you do the following:
• Disconnect the power cord after every use, especially when children are present.
• Clean the treadmill after use.
• Use a dry cloth to cover the control panel and areas around the on/off switch clean.
• Use a soft clean cloth and detergent to remove stubborn stains and dirt from the tread-
mill.
• Tighten the treadmill once a month.
• Keep your treadmill away from heat and water in a safe, dry place.
Regular maintenance prolongs the life of your treadmill and prevents injury!
7
Publicité
