Publicité
Les langues disponibles
Les langues disponibles
TROUBLE SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine will
turn off automatically to prevent any injuries to the user and to prevent damage to the
machine (i.e. motor).
When the treadmill behaves eratically, simply reset the treadmill by turning the power
switch off, waiting for 1 minute then turning the power button back on.
ALARM SIGNALS
E02 Over voltage protection of motor
• Make the machine self-checking again.
• Change controller.
E03 Over current protection
• Clean the dust between running board and belt, then put some oil.
• If the running belt wear seriously, please change the running belt.
E04 Motor open circuit
• Check the check the connect wire of motor ,if the connect wire loose, please connect it
again.
EN
• The motor carbon brush wear, replace carbon brush or motor.
E05
EEPROM damage or access problems change the controller board.
E06 Communication error
• Check the connect wire between computer and controller board, if it loose or broken,
please connect it again or change it.
• Change the incline motor.
E09 short-circuit protection
Change the controller board.
"__" Safety key not connected.
Insert the safety key.
No Power
• Check fuses (They are located on the controller under the motor cover). .
• Check power outlet (Plug something else into the power outlet to ensure that the power
outlet is working correctly).
• Check Power Cable (You may need to take it to an electrician).
8
Publicité
