CONSTRUCTA CF234650 Mode D'emploi page 72

Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
m
Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Push the hook-in rack upwards at the front and unhook to the
1.
side (figure A).
Pull the hook-in rack forwards at the rear and unhook to the
2.
side (figure B).
A
Faults and repairs
In the event of a fault, check the tips in the following table
before calling the after-sales service.
Problem
Electrical operation is malfunctioning (e.g.
indicator lamps do not light up)
Liquid or thin dough runs to one side
Appliance no longer works, ‹:‹‹ flashes in
the clock display
‹:‹‹ flashes on the clock display, "rrr"
appears on the temperature display
"E011" appears in the temperature display Permanent assignment of a button
The temperature display shows, "EXXX",
e.g. E300
Appliance operation is not possible, D
and -†- appear in the temperature display
Appliance operation is not possible, D
and -†˜ appear in the temperature display
The appliance does not heat up, the two
dots flash on the clock display ‚‡‹©
appears in the temperature display, for
example
Electronically controlled functions are
malfunctioning
When an operating mode is switched on, •
or œ appears in the temperature display
The appliance has switched off
automatically, ‹‹‹ flashes in the
temperature display
Smoke is generated during roasting or
grilling
72
B
Possible cause
Faulty fuse
Appliance not installed level
Electricity supply was cut
Power supply was interrupted while the
appliance was in operation
Internal fault in the appliance electronics
The appliance has been locked
The appliance controls are locked
permanently
A button combination was actuated
Energy surges (e.g. lightning strike)
The appliance has not cooled down fully
The appliance has switched off to protect
itself from overheating
Fat is burning on the grill element
Wire rack or universal pan inserted
incorrectly
Clean the hook-in rack with washing-up liquid and a sponge
3.
or brush.
Align the hook-in rack with the indentation (a) facing
4.
downwards, so that the shelf heights match.
Insert the hook-in rack at the rear as far as it will go and push
5.
to the rear (figure C).
Insert the hook-in rack at the front as far as it will go and
6.
push downwards (figure D).
C
a
m
Risk of electric shock!
Work on the appliance electronics may only be performed by
an expert. Disconnect the appliance from the power supply.
Switch off the circuit breaker or take out the fuse in the
household fuse box.
Remedial action
Check fuses in the fuse box and replace if
necessary
Check the appliance installation (see the
Installation instructions)
Reset the clock (see section: Electronic
clock)
Press the clock function button.
Cancel the permanent assignment of the
button and press the clock function button
Press the clock function button. If the
message does not go out, pull out the
mains plug and plug it back in again after
approx. 10 seconds
Deactivate lock (see section: Childproof
lock)
Deactivate permanent lock (see
section: Childproof lock)
Switch off the appliance, press and hold
the info button for 3 seconds, then press
and hold the clock function button for 4
seconds before pressing and holding the
info button again for a further 3 seconds
Reset the function concerned
Wait until the appliance has cooled down,
then switch on the operating mode again
Press any button or turn the selector, the
appliance switches back on
Continue grilling or roasting until the fat on
the grill element is burnt away
Place the wire rack in the universal pan
and insert them together at a lower shelf
height
D
a