CONSTRUCTA CF234650 Mode D'emploi page 60

Operating the appliance
In this section, you will find out how to use your appliance,
change the basic settings, and when your appliance switches
off automatically.
Switching on the appliance
Turn the operating mode selector until the symbol for the
1.
desired operating mode illuminates.
A default temperature appears on the temperature display.
Turn the temperature selector to change the default
2.
temperature.
The appliance begins heating.
Notes
The steam cooking é and Hydro clean > operating modes
■
can only be started if neither • nor œ are displayed in the
temperature display.
If no default temperature is displayed, the temperature for
■
your selected operating mode is a fixed setting. You cannot
change this temperature.
Operating mode
3 Hot air
A Defrost
% Top/bottom heat
0 Circotherm intensive
ë Bread-baking
$ Bottom heat
4 All-round grilling
+ Full-surface grill
( Centre-area grill
é Steam cooking
> Hydro clean
\ Light
Current temperature
Press the info button. The current temperature appears for 3
seconds.
Note: The current temperature can only be displayed with
operating modes with a default temperature.
60
Default Temperature
temperature in range in °C
°C
160 40 - 200
Fixed setting -
170 50 - 275
220 50 - 275
200 180 - 220
200 50 - 225
170 50 - 250
220 50 - 275
180 50 - 275
Fixed setting -
Fixed setting -
Fixed setting -
Heating indicator
The heating indicator displays the rising temperature in the
cooking compartment.
Temperature reached (figure A)
■
Appliance reheating (figure B)
■
A
Switching off the appliance
Turn the operating mode selector to the Û position. The
appliance is switched off.
The appliance has a cooling fan. After the appliance is
switched off, the cooling fan may continue to run.
You can see in the temperature display whether there is high or
low residual heat in the cooking compartment.
Temperature Meaning
display
Residual heat high (above 120 °C)
•
Residual heat low (between
œ
60 °C and 120 °C)
Changing the basic settings
Your appliance has various basic settings, which are preset at
the factory. You can, however, change these basic settings as
required.
The appliance must be switched off and controls must not be
locked.
Press and hold the info button for 3 seconds to go to the
1.
basic settings menu.
™‚‹ appears in the temperature display.
Press the info button briefly and repeatedly until the setting
2.
symbol for the current basic setting of a submenu is
displayed in the temperature display (e.g. ™„ƒ).
Using the temperature selector, set the required basic setting
3.
within a submenu (e.g. ™„„).
Press and hold the info button for 3 seconds.
4.
Your basic setting is saved.
You can change the following basic settings:
Basic settings menu
Submenu Basic setting
Childproof lock Appliance controls
unlocked
Appliance controls locked
Appliance controls
permanent lock
Audible signal Audible signal off
Audible signal 30 seconds
Audible signal 2 minutes
Audible signal 10 minutes
B
Setting
symbol
™‚‹
™‚‚
™ƒ‚
™‚‹
™„‚
™„ƒ
™„„