CONSTRUCTA CF234650 Mode D'emploi page 61

Automatic safety cut-out
The automatic safety cut-out is activated if your appliance is
switched on and you have not made any settings for a long
time.
The length of time after which your appliance switches itself off
depends on the settings that you make.
Electronic clock
In this section, you can read about
how to set the timer
■
how to switch off your appliance automatically
■
how to switch your appliance on and off automatically
■
(preset operation)
how to set the time
■
find out how to activate rapid heat up
■
Clock function
Minute minder
Q
Cooking time
x
End of operation
y
Preset operation
Clock
3
Rapid heat up
f
Notes
When you set a clock function, the time interval increases
■
when you set higher values (e.g. cooking time up to‚:‹‹œ to
the minute, using ‚:‹‹œ to the nearest 5 minutes).
Between ƒƒ:‹‹ and †:†Š the clock display is darkened if
■
you do not alter any settings during this time or if no clock
function is activated.
For the Q minute minder, x cooking time, y end of
■
operation and preselection mode clock functions, a signal
sounds when the settings have elapsed and the Q or y
symbol flashes. To cancel the audible signal early, press the
clock function button.
Switching the clock display on and off
Press and hold the clock function button for 6 seconds.
1.
The clock display switches off. If a clock function is active,
the associated symbol remains lit.
Press the clock function button briefly.
2.
The clock display switches on.
Minute minder
Press the clock function button repeatedly until the KJ
1.
and Q symbols light up.
Set the duration using the rotary selector (e.g. †:‹‹ minutes).
2.
The setting is applied automatically. Then the time is
displayed again and the timer starts counting down.
Use
You can use the minute minder as an egg timer or a kitchen timer. The appliance does
not switch on or off automatically
The appliance switches off automatically after a cooking time setting has elapsed
(e.g. ‚:„‹ hours)
The appliance switches off automatically at a set time (e.g. ‚ƒ:„‹ o'clock)
The appliance switches on and off automatically. Cooking time and end of operation
have been combined.
For setting the clock
For shortening the heat up time
‹‹‹ flashes in the temperature display. Appliance operation is
interrupted.
Turn the operating mode selector to the Û position to deactivate
it.
Clock display
Clock function button
Cooking time
Automatic switch-off after a cooking time setting has elapsed.
Set the operating mode and temperature.
1.
The appliance heats up.
Press the clock function button until the KJ and x symbols
2.
light up.
Set the cooking time with the rotary selector
3.
(e.g. ‚:„‹ hours).
The setting is applied automatically. Then the clock is
displayed again and the set cooking time starts counting
down.
Rotary selector
61