Parkside PWSA 12 B1 Traduction Des Instructions D'origine page 14

GB IE NI
The device must only be op-
erated with the protective
hood mounted.
1. Remove the battery (9). Press the bat-
tery release buttons (8) and pull the
battery (9) out of the tool.
2. Turn the protective hood (1) into the
working position. The closed side of
the protective hood must always face
the operator.
Installing/changing the
cutting/grinding disc
Before initial operation,
check the tightness of the
clamping screw (3).
1. Press the spindle retaining tab (4) and
keep it pressed.
2. Loosen the clamping screw (3) with the
Allen key (11). You can now release
the spindle retaining tab (4).
3. Position the desired cutting/grinding
disc (2) on the mounting flange (12).
The label on the cutting/grinding disc
should always face the tool.
4. Reposition the clamping flange (13).
The side of the clamping flange (13)
with recess generally points to the at-
tachment tool and thus to the cutting/
grinding disc (2). The side with the
marking on the clamping flange
must be visible.
5. Press the spindle
tighten the clamping screw (3) using
the Allen key (11). You can now re-
lease the spindle retaining tab
If the direction of rotation is marked
on your cutting/grinding disc,
make sure that it matches the direc-
tion of rotation mark on the tool.
14
retaining tab (4) and
(4).
Operation
Caution!
Risk of injury!
- Only use grinding tools which bear in-
formation about the manufacturer, type
of binding, dimension and permitted
number of revolutions.
- Only use grinding discs where the
printed rotational speed is at least as
high as what has been specified on the
name plate of the device.
- Do not use any broken, cracked, or
erwise damaged grinding discs.
- Never operate the device without pro-
tective equipment.
- Support the plates or workpieces in or-
der to reduce the risk of kickback from
a jammed cutting disc. Large workpiec-
es may bend under their own weight.
The workpiece must be supported on
both sides of the disc, not only near the
cutting disc, but also at the edge.
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
Information
on replacement:
• Never operate the device without pro-
tective equipment.
• Ensure that the rotation speed stated on
the grinding disc (
or higher than the nominal rotation
speed of the device.
• Ensure that the grinding disc dimen-
sions match those of the device.
• Only use flawless grinding discs (ring-
ing test: when you strike the grinding
disc with a plastic hammer, it results in
a clear sound).
• Never re-drill a locating hole which is
too small to make it larger.
oth-
11) is the same