Parkside PWSA 12 B1 Traduction Des Instructions D'origine page 16

GB IE NI
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out of
the cut through lack of control.
Cutting of stone materials:
• It is best to use a diamond cutting disc
to cut stone materials. Make sure in
any case that the cutting disc is suitable
and labelled for your application.
• When cutting stone materials, ensure
that there is sufficient dust extraction.
• Wear a dust protection mask.
• The device may only be used for dry
cutting/dry grinding.
Information on building statics:
Slits in structural walls are subject to the stand-
ard DIN 1053 Part 1 or country-specific regu-
lations. These regulations must be observed
without fail. Before beginning work you
should ask the structural engineer, architect or
relevant construction supervisor for advice.
Scrubbing wheels:
Never use a cutting wheel for
scrubbing !
Exert only moderate pressure on the work-
piece. Move the device evenly back and
forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
16
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the position-
ing of screws or other parts. Examine the
grinding disc in particular. Exchange the
damaged parts.
Cleaning
Do not use any cleaning agent or
solvent. Chemical substances can etch
the plastic parts of the device. Never
clean the device under running water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
Storage
• Store the device in a dry and dustproof
location and out of reach of children.
• Before prolonged storage, remove the
rechargeable battery from the device
and charge it fully.
• The storage temperature for the recharge-
able battery and the device is between
0°C and 45°C. Avoid extreme cold or
heat during storage to ensure the battery
output is not adversely affected.
• Cutting/grinding discs must be dry and