Télécharger Imprimer la page

Parkside PWSA 12 B1 Traduction Des Instructions D'origine page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Your clothing may accidentally come
into contact with the rotating attachment
tool and get caught and the attachment
tool could drill into your body.
• Clean the ventilation slots of
your electric tool routinely. The
motor air pulls dust into the housing
and, should too much metallic dust col-
lect, could cause electrical hazards.
• Never use the electric tool near
flammable material. Sparks could
ignite this material.
• Do not use attachment tools
which require liquid coolant.
Using water or another liquid coolant
could lead to electrical shock.
Additional safety instructions
for all applications
Kickback and corresponding pre-
cautions
Kickback is the sudden reaction from a
chopping or blocked grinder attachment
such as a grinding disc, grinding plate,
wire brush etc. Chopping or blocking leads
to sudden stopping of the rotating attach-
ment. This causes an uncontrolled electric
tool to accelerate in a direction counter to
the rotational direction of the attachment
tool. If, for example, a grinding disc cuts
into the workpiece or blocks it, the edge of
the grinding disc that digs into the work-
piece can get caught and, through that,
break off the grinding disc or cause a kick-
back. The grinding disc then moves towards
or away from the operator, depending on
the direction of rotation of the disc at the
blocked spot. Here, the grinding discs can
also break. A kickback is caused by wrong-
ly or incorrectly operating the electric tool.
It can be avoided by suitable cautionary
measures, such as described below.
a) Hold the electric tool very firmly and
bring your body and your arm into a
position in which you can resist the kick-
back force. Always use the supplemental
handle if available to give you the best
control over kickback force or reaction
time during acceleration. The operator
can master the kickback and reaction
force through suitable precautions.
b) Never bring your hands near a rotating
attachment tool. The attachment tool can
run over your hand in the kickback.
c) Keep your body away from the area in
which the electric tool would move during
a kickback. The kickback drives the electric
tool in the counter-direction to the rotation
of the grinding disc at the blocked spot.
d) Work particularly cautiously in corner
areas or where there are sharp cor-
ners etc. Prevent the attachment tools
from recoiling from the workpiece and
jamming. The rotating attachment tool
tends to jam when near corners, sharp
edges or when it recoils from such. This
causes a loss of control or kickback.
e) Do not use chain or toothed saw blades.
Such attachment tools frequently cause
a kickback or loss of control over the
electric tool.
Special safety instructions for
grinding and cutting
a) Use only grinders which have been
approved for your electric tool and
the protective hood intended for these
grinders. Grinders which are not in-
tended for the electric tool may not be
sufficiently shielded and are unsafe.
b) Depressed Center grinding wheels
must be pre-assembled so that their
surface not above the level of the edge
of the guard stands out. An improperly
mounted grinding wheel, which ex-
GB
IE
NI
11

Publicité

loading

Ce manuel est également adapté pour:

385625 2107