Parkside PWSA 12 B1 Traduction Des Instructions D'origine page 12

GB IE NI
tends beyond the level of the edge of
the guard, not sufficiently shielded.
c) The protective hood must be securely
attached to the electric tool and adjust-
ed so that the greatest level of safety
is reached, i.e., the smallest possible
amount of the grinder is exposed to the
operator. The protective hood should
protect the operator from broken bits
and accidental contact with the grinder.
d) Grinders may only be used for the
recommended attachment options. For
example: Never grind with the side
surface of a cutting disc. Cutting discs
are for cutting material using the edge
of the disc. Pushing sideways on these
grinders can break them.
e) Always use undamaged clamping
flanges of the correct size and shape
for the grinding disc you selected.
Suitable flanges support the grinding
disc and thus reduce the danger of the
grinding disc breaking. Flanges for
cutting discs can be distinguished from
flanges for other grinding discs.
f) Do not use worn grinding discs for
larger electric tools. Grinding discs for
larger electric tools are not set up for
the higher rotation speeds of smaller
electric tools and can break.
Other special safety instructions for
cutting grinding
a) Avoid blocking the cutting disc or
pressing down too hard. Do not make
any excessively deep cuts. Overload-
ing the cutting disc increases wear and
its tendency to tilt or block and, with
that, to kickback or break the grinder.
b) Avoid the area in front of and behind
the rotating cutting disc. When you
move the cutting disc by itself in the
workpiece, in the event that the electric
12
tool kicks back with the rotating disc, it
can spin directly towards you.
c) If the cutting disc jams, or you interrupt
your work, switch the device off and
hold it until the disc has come to a full
stop. Never try to pull the cutting disc
out of the cut while it is still running,
because it can kick back. Identify and
correct the cause of the jamming.
d) Do not switch the electric tool on again
as long as it is in the workpiece. Al-
low the cutting disc to first reach its full
rotational speed before you carefully
resume with the cutting. Otherwise, the
disc may catch, spring away from the
workpiece or cause a kickback.
e) Support plates or workpieces to reduce
the risk of kickback from a jammed cutting
disc. Large workpieces may bend under
their own weight. The workpiece must be
supported on both sides of the disc, near
the cutting disc as well as also at the edge.
f) Be particularly careful for pocket cuts in
existing walls or other areas where you
cannot see what is there. The cutting
disc may cause a kickback when it cuts
into gas or water lines, electrical lines
or other hidden objects.
Additional safety instructions
• Only use grinding discs where the in-
dicated rotational speed is at least as
high as what has been specified on the
name plate of the device.
• Carry out a visual inspection of the grind-
ing disc before use. Do not use any dam-
aged or deformed grinding discs. Replace
any damaged or worn grinding discs.
• Make sure that the sparks produced by
grinding do not present a danger, e.g.
reach people or ignite flammable sub-
stances.
• Always wear safety goggles, safety