Parkside PWSA 12 B1 Traduction Des Instructions D'origine page 15

• Never use separate bushings or adapt-
ers in order to make grinding discs with
a hole that is too large fi t the device.
• Do not use any saw blades.
• To clamp the grinding tools only use the
clamping fl ange provided. The pads be-
tween the clamping fl ange and the grind-
ing tools must be made of elastic materials
e.g., rubber, soft cardboard etc.
Switch off the tool and remove the
battery before you service the tool.
Wear protective gloves when
changing the cutting/grinding discs
in order to avoid injuries from cuts.
The clamping screw (
be too tight in order to avoid break-
ing the cutting/grinding disc (
Inserting/removing the
rechargeable battery
1. To insert the battery (9) into the device,
push the battery along the guide rails
into the device. You will hear them click
into place.
2. To remove the battery (9) from the de-
vice, press the release button (8) on the
battery and pull the battery out.
Checking the battery charge
level
The battery's ( 9) charge level is indi-
cated by the charge state indicator (
The LEDs indicate the battery's charge
•
level, when the device is in operation. To
switch on, push the pressure point on the
on/off switch (
slide the on/off switch (
3) must not
5a) downwards and
5) forwards.
red-yellow-green
=> Battery fully charged
red-yellow => Battery half charged
red => Battery needs to be charged
Switching on and off
1. To switch on, push the pressure point on
the on/off switch (5a) downwards and
slide the on/off switch (5) forwards. The
tool turns on and starts. To engage the
tool, push the on/off switch (5) forwards.
2. To switch off, push the pressure point
on the on/off switch to allow you to tilt
the on/off switch (5) downwards.
The tool will switch off.
After switching on the device, wait until the
device has reached its max. speed. Only
2). then should you start with the work.
The disc still runs even after
the device has been switched
off. Risk of injury.
Trial run:
Always carry out a trial run before carrying
out your fi rst grinding procedure and after
every disc replacement. Switch the device
off immediately if the grinding disc is not
rotating smoothly, if considerable vibration
occurs or if you hear abnormal noises.
Practical tips
Cutting disc:
6).
Never use a scrubbing wheel
for cutting !
Only certifi ed, fi bre-reinforced cutting or
grinding discs may be used.
In general, work with small scrubs. Exert
GB IE NI
15