Publicité
Les langues disponibles
Les langues disponibles
SUBSTITUTING THE NOZZLE IN THE MAIN BURNER Fig.A
•
Remove the front fixing screws from the panel (see figure A, pos. 02), remove the start up cable from the
piezoelectric ignition device (03).
•
Using a suitable spanner, unscrew the nozzle (09) and substitute it with the right one (see table of "burners"
technical data).
•
The main burner does not require any regulation of the primary air.
SUBSTITUTING THE NOZZLE IN THE PILOT BURNER Fig.A
La fiamma del bruciatore pilota ha l'aria fissa.
L'unica operazione necessaria é la sostituzione dell'ugello (08) secondo il tipo di gas.
Bisogna quindi svitare le viti come specificato al punto precedente con una chiave adeguata svitare il raccordo) e
sostituire l'ugello (08) con uno adeguato. Con l'ugello adatto la fiamma deve lambire la termocoppia (06).
After having effected the conversion to another type of gas, it is necessary to update the data plate, indicating the type
of gas for which the appliance has been converted.
•
The appliance contains the instructions necessary for use.
•
Check the appliances for gas leaks.
•
Examin the flame of the pilot burner; it must lap the thermocouple and be blue, otherwise examine the nozzle of
the pilot burner.
•
Check the lighting and flame of the main burner.
•
We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is indispensable to carry out regular maintenance for the safe functioning of the
appliance; we therefore reccomend drawing up a contract for after slaes service.
Maintenance must be done only by specialized personnel, observing the norms in force and our indications.
It is possible to substitute parts such as the valve, the piezoelectric lighter or gas pipes very simply.
To substitute the parts, procede as follows:
•
Valve: after removing the front panel, unscrew the screwed fittings (04-05) of the gas connections and take out the
bulb of the thermostat, then substitute the faulty parts, installing the new ones.
•
To substitute the thermocouple, unscrew the fitting (06) of the valve and substitute the element.
•
The spark plug (07) must be unscrewed and substituted.
Attention! In the event that smoke is given off, when the appliance is started up, it is necessary to let the installation
function without being used, for approximately an hour or until the smell disappears.
Push and turn the thermostat knob (01) into position
Keeping the knob pushed down, press the piezo button (03) repeatedly. The flame lights automatically and can be seen
trough the inspection hole in the front panel. After lighting, hold the knob down for another 5-10 seconds, to allow the
thermocouple to warm up, then release it. The flame may go out, in which case it is necessary to repeat the procedure.
After releasing the knob, the gas goes into the safety valve. Turning the graduated knob from 60 to 300° C, the gas goes
to the main burner whcih then lights.
Turn the knob into position
Push and turn the knob into position "0". This command blocks the gas supply to both the main burner and the pilot
burner.
GB
Important!
CHECKING FUNCTIONING
MAINTENANCE
SPARE PARTS Fig.A
INSTRUCTIONS FOR USE
LIGHTING THE MAIN BURNER
Lighting the pilot burner
Lighting the main burner and regulating the temperature
Putting out the main burner
;only the flame of the pilot burner remains lit.
Turning off the appliance
IE
26
Publicité
