Reflex Servitec 35 Mode D'emploi Original page 34

Description of the device
With this setting, the make-up water is degassed. A system degassing
does not occur.
Make-up variants
There are two make-up variants for the device. These are selected in the
controller and set for the device:
•
Make-up variant Magcontrol.
For facility systems with expansion vessels. The pressure in the facility
system is monitored with the aid of the integrated pressure sensor in the
device. If the plant pressure falls below the calculated filling pressure,
water make-up is triggered.
•
Make-up variant Levelcontrol.
For facility systems with pressure maintaining stations. The water level in
the expansion vessel of the pressure maintaining system is determined
with the "LIS" external pressure transducer. If the water level in the
expansion vessel falls, a signal is switched from the pressure maintenance
station to the Servitec to activate the make-up.
Servitec 35 - 95 with motorized ball valve
1 Control line of a pressure maintenance station for requesting the
make-up in "Levelcontrol" mode
2 Signal line from the "PIS" pressure transducer for the "Magcontrol"
make-up variant
3 "DC" degassing line (degassed water)
4 "DC" degassing line (gas-rich water)
5 "WC" make-up line
Optional equipment and accessories  4.5 "Optional equipment and
6
accessories",  34
7 Control Touch controller
4.4 Scope of delivery
The scope of delivery is described in the shipping document and the content is
shown on the packing.
Immediately after receipt of the goods, please check the shipment for
completeness and damage. Please notify us immediately of any transport
damage.
Basic degassing equipment:
•
Control of the Servitec.
•
"DV" degassing valve, box-packaged.
•
Plastic sleeve with operating manual and electric wiring diagram (attached
to the Servitec).
The Servitec is pre-assembled and shipped on a pallet.
34 — English
4.5
The following optional equipment and accessories are available for this device:
•
•
•
•
•
•
•

Vacuum spray degassing — 01.04.2022-Rev. D
Optional equipment and accessories
Fillsoft/Fillsoft zero for softening/desalination of the make-up water from
the potable water supply system. Replacement of the softening and
desalination cartridges.
Fillset for make-up with water
–
Fillset with integrated backflow preventer, water meter, dirt trap, and
shut-ff for the "WC" make-up line
Fillset Impulse with FQIR+ contact water meter for make-up with water.
–
If the Fillset Impulse is installed, you can regulate the entire make-up
quantity and the soft water capacity of Fillsoft softening systems. The
operational reliability of the device is assured and prevents automatic
make-up during major water loss or small leaks.
Fillset Compact for make-up
–
Fillset Compact with integrated system separator, dirt trap, and shut-
off for the "WC" make-up line.
Fillguard for conductivity monitoring
–
If the Fillguard is fitted, the capacity of the Fillsoft Zero desalination
cartridge can be monitored based on the conductivity.
Enhancements for the device controller.
–
Various controller information can be queried via the RS-485
interface and it can also be used to communicate with control centres
or other devices,  6.5.3 "RS-485 interface",  40.
•
Bus modules for the communication with control centres.
•
Profibus-DP.
•
Ethernet.
•
I/O module for standard communication.
•
Modbus RTU
•
Control Remote
Gas discharge measurement for optimised degassing operation.
Note!
Separate operating manuals are supplied with accessories.