Publicité
Les langues disponibles
Les langues disponibles
TCD 2044
2.0 - INSTALLATION
2.2 - Control installation
4
ADHESIVE
GASKET
• Clean the surface before installation.
4
•
- Detach the protective paper from the gasket taking
care not to touch the adhesive side with your fingers.
WARNING
It is recommended not to apply the
adhesives (gasket and polycarbonate)
18°
at a temperature below 18° C.
5
5
•
- Insert the control into the hole and press it to make
it adhere well to the surface. Tighten the four self-
tapping screws provided to secure it to the panel.
• Use M3 countersunk screws (not supplied) to fix the
device on metal sheet.
18
6
• Clean the surface of the control before application.
6
•
label. For a better seal, avoid touching the adhesive part
with your fingers.
7
7
•
- Apply the adhesive from above.
Press the entire surface firmly to make it stick well.
8
8
•
protective film from the control surface.
• It is recommended to use a piece of adhesive tape to
remove the transparent film.
INSTALLATION AND USE MANUAL - REV 002A
GUARNIZIONE
ADESIVA
- Remove the protective paper from the back of the
- At the end of installation, remove the transparent
EN
ADHESIVE
POLYCARBONATE
TRANSPARENT
PROTECTIVE FILM
Publicité
