Publicité
Les langues disponibles
Les langues disponibles
20. Starting/stopping the device
STARTING THE ENGINE
WARNING!
The cutting blade starts to move when the Engine is started.
8. release the throttle and make sure that it is fully down (F1)
9. set the ignition switch to "I (run) (F1)
10. press the starter injection pump (primer pump) several times until fuel flows in
the transparent tube (F2)
11. move the choke lever to the closed position. (F3)
(1) Throttle lever
(2) Ignition switch
(3) Stop
(4) Start
(5) Starter injection pump
(6) Fuel line
(7) Choke lever
(8) Open
(9) Closed
12. place the equipment on a flat, solid surface. The cutting head must remain free
and must not encounter any obstacles.
13. hold the equipment firmly and pull the starter cord quickly and firmly until the
Engine responds (2-3 strong pulls).
14.
IMPORTANT: Engine has not started (it only indicates that it wants to start).
Then press the throttle lever (1) so that the choke lever
returns to the open position. Then pull the starter cable until the Engine runs.
IMPORTANT!
Do not pull the starter cable all the way to the end and do not let it spring back
-
by releasing the knob. This could lead to starter errors.
Push the choke lever down to open the choke. (F3)
-
Let the Engine warm up for a few minutes before starting work.
-
NOTE
3. if the Engine is to be restarted immediately after switching off, the choke must be
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
- Towards the throttle stick
39
automatically
Publicité
