FUXTEC FX-MH126 Manuel D'utilisation page 40

left open (F3)
4. too much choke can lead to starting problems due to overly excessive fuel flow. If
the Engine cannot be started after several attempts, open the choke and pull the
starter cable repeatedly or remove the spark plug and dry it.
STOPPING THE ENGINE (F1)
1. release the throttle valve lever and let the Engine run for half a minute
2. move the ignition switch to the "0"(STOP) position
NOTE
If the Engine does not stop after switching off, close the choke so that the Engine stops
after a while.
IMPORTANT
During the first 20 hours of operation, the hedge trimmer should not be used at full
power for long periods.
ADJUSTING THE IDLE SPEED
Before adjusting the carburettor, clean the air filter and let the Engine run warm.
-
The idle limiting screw is adjusted so that there is a sufficient safety margin between
-
the idle speed and clutch engagement.
(1) Air filter (F5)
(2) Idle speed limiter screw (F6)
WARNING!
When the Engine is idling (2,700 ~ 3400 rpm), the blade should not move. You can
adjust the carburettor yourself (please contact our customer service). However, we
recommend having this done by an authorized mechanic.
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
40