Publicité
Les langues disponibles
Les langues disponibles
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
18. Intended use / not intended use
The petrol-powered hedge trimmer is exclusively intended for cutting hedges or bushes.
The maximum branch diameter of the hedge must not exceed 28mm.
Proper use also includes reading and adhering to the operating instructions before each
use. Before and during use, the hedge trimmer must be checked for mechanical
damage. If repairs are necessary, please contact us.
Only spare parts approved by the manufacturer or original spare parts may be used. The
hedge trimmer may only be operated in open garden areas.
If non-approved or non-original spare parts are used, the operator and not the
manufacturer is liable for any damage to property or persons.
Any use other than that mentioned above is an improper use.
Other risks
Even when the tool is used properly, there is always a certain amount of residual risk
that cannot be excluded. The following potential hazards can be identified from the type
and design of the tool:
- Contact with the unprotected shear blade (cutting injuries).
- Reaching into the operating hedge trimmer (cutting injuries).
- Unforeseen, sudden movement of the clippings (cutting injuries).
- Throwing away defective shearing teeth.
- Centrifuging of parts of the material to be cut.
- Damage to hearing if prescribed hearing protection is not worn.
- Inhalation of cutting material particles, exhaust gases from the combustion engine.
- Contact of petrol on the skin.
- Burns from touching hot surfaces.
Warning: The actual existing vibration emission value during the use of the device may
differ from the value specified in the instruction manual or by the manufacturer. This can
be caused by the following influencing factors, which should be observed before or
during use:
- Is the device being used correctly?
- Is the cutting method of the material or how it is processed correct?
- Is the condition of the device correct when used?
- Is the cutting tool sharp or is it the correct cutting tool?
33
Publicité
