FUXTEC FX-MH126 Manuel D'utilisation page 41

USE:
WARNING!
Proceed as follows:
5. release the handle by pressing the locking lever.
6. Turn the handle until the locking lever audibly engages.
7. When the grab handle is locked in its new position, the throttle can be operated
again.
(1) Handle
(2) Locking lever
8. only use as much gas as the use of the equipment requires. excessive Engine
speeds are not necessary.
Avoid cutting thicker branches as this may damage the cutting blades and
-
shorten the life of the power system.
If the equipment is held at an angle of 5-10° to the object to be cut, the work
-
can be done more easily and the cutting will be more attractive.
Always hold the body on the carburettor side of the equipment, never on the
-
exhaust side.
When a new piece of equipment is used for the first time, grease may leak out of
-
the gear case during the first few minutes. Since this is excess grease, there is
no reason for concern. Just wipe it off when you stop the equipment again.
21. Refuelling the device
WARNING!
Gasoline is very highly flammable. Avoid smoking or handling naked flames or
-
sparks near the fuel.
Remove all obstacles before starting work.
-
Also ensure that the Engine has stopped and cooled down before refuelling.
-
For this purpose, a free area outside of buildings must be selected.
-
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
For easy trimming of hedges, the
handle can be turned 90° to the right
or left.
Do not operate the throttle during
this procedure!
41