FUXTEC FX-MH126 Manuel D'utilisation page 47

23. Storage of the device
WARNING: If you do not follow these steps, deposits may form in the
carburettor. This makes it difficult to start later and causes permanent
damage.
1. Performing all general maintenance as described in the maintenance section of your
user manual are recommended.
2. Clean the exterior of the device, drive axle, protective shield and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After the fuel is drained, start the device.
5. Have the device idling until the device stops by itself. This will clean the carburettor of
fuel.
6. Let the device cool down (about 5 minutes).
7. Using a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter
cord
Slowly several times to coat internal components. Replace the spark plug.
9. Store the device in a cool, dry place away from any ignition source such as an oil
burner, water heater, etc.
TRANSPORT SAFETY
Make sure that the device is well secured during transport to avoid fuel loss, damage or
injury. Install a transport protection system of metal sheets during transport and
storage.
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
47