Publicité
Les langues disponibles
Les langues disponibles
d.
When refuelling, wipe off any spilled fuel thoroughly with a dry cloth.
e.
After refuelling, tighten the fuel filler cap and move the equipment about 3 m from
the refuelling location before starting the Engine.
TRANSPORT
a.
During transport, it is imperative that the enclosed protective cover or other suitable
protective coverings be used.
b.
When transporting the equipment in vehicles, make sure that it cannot tip over
during transport.
c.
If the ddevice is transported over long distances or in vehicles, the fuel tank must be
emptied beforehand to prevent fuel spillage during transport.
WORKING CONDITIONS
a.
Wear suitable clothing and protective equipment when working with this equipment:
(1) Protective helmet (You must wear a helmet when working on sloping ground).
(2) Safety goggles or face protection
(3) Tight protective gloves
(4) Non-slip work shoes
(5) Hearing protection (especially for long-term work)
b.
The following must also be carried:
(1) Combi-tool
(2) Fuel for refilling
(3) Spare cutting blade (if available)
(4) Ropes, warning signs, etc. For marking the working area
(5) Whistle (for communication with employees and for emergencies)
(6) Axe or saw (to remove obstacles)
c.
Do not wear loose clothing, jewellery or short trousers and do not work in sandals or
barefoot.
BEFORE STARTING THE ENGINE
a.
Check equipment for loose fastenings and leaking fuel. Check cutting tools for
proper mounting and tightness. In particular, the cutting edge and its connecting part
must be checked carefully.
b.
The cutting edge can only be used if it is ensured that there are no cracks or bends
in the cutting edge. Damaged cutting edges must not be used under any circumstances.
c.
Only use sharp cutting edges.
d.
To avoid chipping of the cutting edges, grind the corners of the blade round.
e.
After mounting the cutting edge and tightening the screw, check that it is properly
fastened. The blade is not permitted to have any play to avoid excessive vibration
throughout operation.
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
36
Publicité
