Publicité
Les langues disponibles
Les langues disponibles
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
System/Component
Fuel leaks, fuel
splashes
Fuel tank, air filter,
fuel filter
idling adjustment
screw
Spark plug
Cylinder fins, air
intake opening
muffler, spark extinguisher,
cylinder outlet
throttle valve lever,
ignition switch
cutting parts
Gearbox housing
Screws/nuts/bolts
Maintenance before long-term storage
IMPORTANT!
When draining the fuel, avoid spilling the fuel. Spillage must be removed and the lid of the
container closed tightly.
1. Have the engine run with an empty fuel tank until it stops on its own to remove any
remaining fuel in the engine
2. Remove the spark plugs and pour 1-2cc of two-stroke engine oil into the engine. Pull the
pull starter 2 - 3 times. Then reinstall the spark plugs.
3. Wet metal parts with anti-rust oil and place the protective cover on the cutting edge.
4. Store the device in a place protected from moisture for storage.
Procedure
Befor
e use
Wipe
X
check/clean
X
Check idle
speed
X
Clean and
readjust
cylinder gap
clean
clean
Check function
X
replace if
something is
X
not correct
Lubricate
tighten/replace
X
46
After
After
After
every 25
every 50
every
hours
hours
100
hours
X
X
X
X
X
Note
Replace if
necessary
Replace
carburettor, if
necessary
GAP: 0.6 - 0.7 mm
Replace if
necessary
not the adjusting
X
screws
Publicité
