FUXTEC FX-MH126 Manuel D'utilisation page 42

IMPORTANT!
RECOMMENDED MIXING RATIO: FUEL 40: OIL 1
Do not use mixed oil (2-stroke water cooling) as this can lead to spark plug
-
contamination and block the exhaust port or cause the piston ring to seize.
Using mixed fuel that has not been used for a month or more may cause the
-
carburettor to clog, resulting in the engine not operating properly. Store excess
fuel in a closed container in a cool place. The air-cooled two-stroke engine
consumes a mixture of quality engine oil and regular gasoline (with or without
lead, but without alcohol).
The Engines should be lubricated with oil that has a special formula for use with
-
air-cooled 2-stroke petrol engines. We recommend here the original FUXTEC 2T
oil (Made in Germany) to ensure the longevity of the Engine.
FUEL MIXTURE
Mix fuel with 2-stroke oil in a container provided for this purpose. Note the following
the mixture table on the following page for correct fuel/oil ratio. Shake the tank to
ensure complete mixing.
Petrol
1 Litre
2 Litre
WARNING: Lack of lubrication rules out the liability of the device manufacturer.
Gasoline and oil may not be mixed in a ratio of more than 40:1.
WARNING
Petrol is highly flammable and can cause an explosion if sparks are produced
⚫
Refuel only in well-ventilated rooms and have the Engine cool down before filling.
⚫
Smoking and open flames as well as any sparks must be avoided throughout
refuelling.
Do not overfill the tank (see figure max. level)
⚫
After refuelling, check that the fuel filler cap is properly closed
⚫
Avoid any spillage of petrol
⚫
Keep the device away from children
⚫
Original Bedienungsanleitung FUXTEC FX-MH126_de_en_fr_ita_rev10
Two-stroke engine oil
(40:1)
0.025 Litre
0.050 Litre
Two-stroke engine oil
Petrol (40:1)
5 Litre 0.125 Litre
10 Litre 0.250 Litre
Tankdeckel
max. Füllstand
42