Parkside PKGA 20-Li C2 Traduction Des Instructions D'origine page 18

GB IE
For certain work, the sawblade
can also be inserted after turning
through 180°.
Operating the sabre saw
1. Before switching the appliance on, ensure
it is not in contact with the workpiece.
2. Turn the appliance on.
By using the on/off switch (10) you can
progressively control the stroke rate.
Gentle pressure: low stroke rate.
Greater pressure: higher stroke rate.
The on/off switch cannot be locked.
3. Place the footplate (17) on the work-
piece.
4. Cut with a uniform forward motion.
5. After completion of the work, first
switch off the device and then remove
the blade from the saw cut.
Sawing
Wear eye protection.
• Use only undamaged sawblades in
perfect condition. Only use metal saw-
blades for metalworking.
• Ensure your stance is stable and hold
the appliance tightly with both hands
and away from your body.
• Before sawing the workpiece, check
for hidden foreign objects such as
nails, screws. These must be removed.
• Plunge cuts may only be made in soft
material such as wood or plaster-
board.
18
Plunge cuts
Risk of kickback! Hold the
device firmly.
1. Place the device with the bottom edge
of the footplate (17) on the workpiece.
2. Turn on the device.
3. Insert the saw blade (19/20) in the
workpiece by tipping the device for-
ward until the device is vertical.
4. Continue sawing along the desired cut-
ting line.
Selection of sawblade
Wood sawblade
Metal sawblade
Plunge sawblade
Motor unit with
multifunction tool
PKGA4
Wear a protective mask during
grinding work.
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Ensure that the tool holder (29) is
tightly screwed in to ensure you can
safely mount and use all the sup-
plied tools (30/32/33).
for wood, plastic, plaster-
board
for metal sheets, profiles
and tubes
for soft materials like
wood or plasterboard