Parkside PKGA 20-Li C2 Traduction Des Instructions D'origine page 14

GB IE
Practical tips
When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Ensure that the ambient tem-
perature does not exceed
50 °C or fall below -20 °C
during work.
Wear ear protection.
Operation
Replacing the appliance at-
tachment
Secure the appliance against
switching on (see "Switch-
ing on/off") or remove the
rechargeable battery from
the appliance. There is an
injury hazard if the device is
switched on accidentally.
Wear safety gloves. The appliance
attachment might have heated up
after use.
Removing appliance attachment
1. Push the unlocking lever (5) into posi-
tion as far as the stop and then
hold it in this position.
14
2. Pull the unlocked appliance attachment
off (4/16/22/26).
Fitting appliance attachment
3. Push the appliance attachment
(4/16/22/26) along the guide rail
into the motor unit (6).
4. Allow the unlocking lever (5) to slide
back into position
5. Check that the appliance attachment is
secure by pulling on it.
Inserting/removing
the battery
1. To remove the battery (9) from the de-
vice, press both release buttons (9b) on
the battery and pull the battery out.
2. To insert the battery (9), push the bat-
tery along the guide rail into the de-
vice. You will hear it click into place.
Only insert the rechargeable
battery once the device is
completely assembled. Risk
of injury!
Switching on/off
1. Switching on: Press the on/off switch
(10).
By using the on/off switch (10) you
can progressively control the speed.
Gentle pressure: low speed
Increase pressure: higher speed.
2. Switching off: Release the on/off
switch (10).
If you place the direction switch
(7) in the middle position, the device is
secured against being switched on.
.