Parkside PKGA 20-Li C2 Traduction Des Instructions D'origine page 16

GB IE
Set the direction of rotation
The appliance's direction of rotation can be
changed with the rotational direction switch.
The arrow on the direction switch indicates
the working direction.
1. Wait for the appliance to come to a
standstill.
2. Push the rotational direction speed
(7) into the desired position:
To drill and screw in screws: Press the
direction switch with the arrow poin-
ting forwards
To unscrew screws: Press the direction
switch with the arrow pointing back-
wards
3. If you place the direction switch
(7) in the middle position, the device is
secured against being switched on.
The direction change may only be
actuated when at a standstill!
Torque adjustment
You can preselect the maximum torque.
The torque settings are labelled 1 - 19 +
1. Wait for the appliance to come to a
standstill.
2. Turn the torque adjusting ring (2) to
select the desired torque:
Screws:
Drilling:
3. Start with a lower torque step and
increase as required.
The direction change may only be
actuated when the appliance is at a
standstill!
16
Steps 1 - 19
Step
The necessary torque is dependent on:
- the type and hardness of the ma-
terial to be treated;
- the type and length of the screws
used.
Motor unit with
multisander
attachment PKGA2
(optionally available)
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear a protective mask during
grinding work.
Attaching/removing sanding
sheet
The sanding plate (21) is fitted with Velcro for
rapid attachment of the sanding sheet.
Attaching sanding sheet
1. Press the sanding sheet (23) evenly onto
the sanding plate (21). Ensure that the
holes in the sanding sheet are placed
above the openings in the sanding plate.
Removing sanding sheet
2. Simply pull the sanding sheet (23) off
the sanding plate (21).
Connecting dust extraction
You can reduce dust production during sand-
ing by attaching a dust extraction system.
1. Push the adaptor (24) into the opening
on the multi-sander attachment (22) as
far as the stop.