Parkside PKGA 20-Li C2 Traduction Des Instructions D'origine page 15

Checking the battery
charge level
The battery's (9) charge level is indicated
by the charge state indicator (9a).
• The charge level of the battery is
indicated by illumination of the corre-
sponding LED lights while the device is
in operation. Press and hold the power
button to view.
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red
=> Battery needs
Charge the battery (9) when only
the red LED on the level indicator is
illuminated.
Recharging the battery
Allow a hot battery to cool before
charging.
Only charge the battery (9) when
the red LED on the charge status
indicator (9a) is on.
1. Remove the battery (9) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (9) in the charging
compartment of the battery charger
(14).
3. Plug the battery charger (14) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (14) from the
mains.
5. Remove the battery (9) from the charg-
er (14).
to be charged
Overview of the control display on
the charger (14):
Green LED lights up without battery in-
serted: Charger ready.
Green LED lights up: Battery such alleged
charged.
Red LED lights up: Battery charging.
Motor unit with drill
attachment PKGA1
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Rotate the keyless chuck (1) towards
RELEASE
until the drill chuck aperture is
large enough to accommodate the tool.
2. Insert the tool as far as possible into
the keyless chuck (1).
3. Turn the keyless chuck towards
order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) towards
the drill chuck aperture is large enough
to remove the tool.
Choice of gear
Stop appliance before
changing gear.
1. Wait for the appliance to come to a
standstill.
2 Slide the gear selector (3) into the re-
quired position:
1: 0-400 min
-1
2: 0-1350 min
GB
GRIP
RELEASE
-1
IE
in
until
15