Parkside PWSA 12 C2 Mode D'emploi page 40

The charge level of the battery is indicated by
o
the LEDs when the product is in operation .
Push the pressure point on the on/off switch
downwards and slide the on/off switch
forwards .
˜ Troubleshooting
Problem
The product does
not start .
The grinding tool
does not move
although the
engine is running .
The engine is
slower and stops .
The grinding disc
does not rotate
smoothly, abnormal
noises can be
heard .
˜ Cleaning and maintenance
m WARNING!
Switch the product off and remove
the battery pack before replacing
attachments, cleaning and when not in
use .
40 GB/IE
5 ] [
Possible cause
The battery is discharged .
[ 9 ]
The battery is not inserted
[ 9 ]
in the product .
The on/off switch is
5 ] [
damaged .
The product is damaged .
The clamping screw
[ 3 ]
loose .
Workpiece, remaining
workpieces or remaining
grinding tools block the drive .
The product is overloaded
through the workpiece .
The clamping screw
3 ] [
loose .
The cutting/grinding disc is
defective .
LED
red-yellow-green
5a ] [
red-yellow
red
Solution
Charge the battery
Insert the battery
Contact the service centre .
is Tighten the clamping screw
changing the cutting/grinding disc") .
Remove the blockages .
Reduce the pressure on the grinding tool .
The workpiece is unsuitable .
is Tighten the clamping screw
changing the cutting/grinding disc") .
Change the cutting/grinding disc
(see „Installing/changing the cutting/grinding
disc") .
m WARNING!
Do not use any cleaning agent or solvent .
u
Chemical substances can etch the plastic
parts of the product .
Never clean the product under running
u
water .
Status
Battery fully charged
Battery half charged
Battery needs to be charged
.
9 ] [
into the product .
9 ] [
(see „Installing/
3 ] [
(see „Installing/
3 ] [