Parkside PWSA 12 C2 Mode D'emploi page 34

15) Do not use accessories that require
liquid coolants. Using water or other liquid
coolants may result in electrocution or shock .
Further safety instructions for all
operations – Kickback and related
warnings:
Kickback is a sudden reaction to a pinched or
snagged rotating wheel, backing pad, brush or any
other accessory . Pinching or snagging causes rapid
stalling of the rotating accessory which in turn
causes the uncontrolled power tool to be forced in
the direction opposite of the accessory's rotation at
the point of the binding .
For example, if an abrasive wheel is snagged or
pinched by the workpiece, the edge of the wheel
that is entering into the pinch point can dig into
the surface of the material causing the wheel to
climb out or kick out . The wheel may either jump
toward or away from the operator, depending on
direction of the wheel's movement at the point of
pinching . Abrasive wheels may also break under
these conditions .
Kickback is the result of power tool misuse and/or
incorrect operating procedures or conditions and
can be avoided by taking proper precautions as
given below .
1) Maintain a firm grip on the power
tool and position your body and
arm to allow you to resist kickback
forces. Always use auxiliary handle,
if provided, for maximum control
over kickback or torque reaction
during start-up. The operator can control
torque reactions or kickback forces, if proper
precautions are taken .
2) Never place your hand near the
rotating accessory. Accessory may
kickback over your hand .
3) Do not position your body in the
area where power tool will move if
kickback occurs. Kickback will propel
the tool in direction opposite to the wheel's
movement at the point of snagging .
34 GB/IE
4) Use special care when working
corners, sharp edges etc. Avoid
bouncing and snagging the
accessory. Corners, sharp edges or
bouncing have a tendency to snag the
rotating accessory and cause loss of control or
kickback .
5) Do not attach a saw chain
woodcarving blade or toothed saw
blade. Such blades create frequent kickback
and loss of control .
Additional warnings specific for grinding
and cutting-off operations
Safety warnings specific for grinding and
cutting-off operations
1) Use only wheel types that are
recommended for your power tool
and the specific guard designed for
the selected wheel. Wheels for which
the power tool was not designed cannot be
adequately guarded and are unsafe .
2) The grinding surface of centre
depressed wheels must be mounted
below the plane of the guard lip. An
improperly mounted wheel that projects
through the plane of the guard lip cannot be
adequately protected .
3) The guard must be securely attached
to the power tool and positioned
for maximum safety, so the least
amount of wheel is exposed towards
the operator. The guard helps to protect
the operator from broken wheel fragments,
accidental contact with wheel and sparks that
could ignite clothing .
4) Wheels must be used only for
recommended applications. For
example: do not grind with the side
of cut-off wheel. Abrasive cut-off wheels
are intended for peripheral grinding, side
forces applied to these wheels may cause them
to shatter .