Parkside PWSA 12 C2 Mode D'emploi page 39

5 . Press the spindle retaining tab and tighten the
clamping screw using the hex key . Release the
spindle retaining tab .
˜ Inserting/removing the
rechargeable battery
Inserting the battery: Push the battery
o
along the guide rails into the product . The
battery clicks into place .
Removing the battery: Press the release
o
button on the battery and pull the battery
[ 8 ]
out .
˜ Operation
m WARNING!
Wear protective gloves when changing
the tool so as to avoid injuries from cuts .
m WARNING!
Switch the product off and remove
the battery pack before replacing
attachments, cleaning and when not in
use .
m CAUTION! RISK OF INJURY!
Only use grinding discs and accessories
u
recommended by the manufacturer . Using
other attachment tools and other accessories
can represent a risk of injury for you .
Only use accessory parts which bear
u
information about the manufacturer, type
of connection, dimension and permitted
number of revolutions .
Only use accessory parts where the printed
u
rotational speed is at least as high as what
has been specified on the name plate of the
product .
Do not use any broken, cracked, or
u
otherwise damaged grinding discs .
Never operate the product without protective
u
equipment .
m CAUTION! RISK OF INJURY!
Support the plates or workpieces in order to
u
reduce the risk of kickback from a jammed
cutting disc . Large workpieces may bend
under their own weight . The workpiece must
be supported on both sides of the disc, not
[ 9 ]
only near the cutting disc, but also at the
edge .
Keep your hands away from the disc when
u
the product is in operation . Risk of injury .
˜ Switching the product on/off
m CAUTION! RISK OF INJURY!
The cutting/grinding disc still runs even after
u
the product has been switched off .
NOTE
After switching on the product, wait until the
u
product has reached its max . speed . Only
then should you start with the work .
Switching on: Push the pressure point on the
o
on/off switch
off switch
5 ] [
on and starts .
Switching off: Release the the on/off
o
switch . The product switches off .
[ 5 ]
Trial run
Always carry out a trial run before carrying out
your first grinding procedure and after every disc
replacement . Switch the product off immediately
if the grinding disc is not rotating smoothly, if
considerable vibration occurs or if you hear
abnormal noises .
˜ Checking the battery charge
level
NOTE
The battery indicator
u
charge level of the battery
downwards and slide the on/
5a ] [
forwards . The product switches
indicates the
6 ] [
.
9 ] [
GB/IE 39