Parkside PWSA 12 C2 Mode D'emploi page 32

2) Do not use the power tool if the
switch does not turn it on and off. Any
power tool that cannot be controlled with the
switch is dangerous and must be repaired .
3) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting the
power tool accidentally .
4) Store idle power tools out of the
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are dangerous
in the hands of untrained users .
5) Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools .
6) Keep cutting tools sharp and
clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and
are easier to control .
7) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation .
Careful handling and use of battery
devices
1) Charge the batteries only in chargers
that are recommended by the
manufacturer. Risk of fire if a charger that
is suitable for a specific type of battery is used
with other batteries .
2) In the power tools, use only
the batteries designed for the
purpose. The use of other batteries may
result in injuries and risk of fire .
32 GB/IE
3) Keep the unused battery away
from paper clips, coins, keys, nails,
screws and other small metal objects,
which could cause bridging of the
contacts. A short circuit between the battery
contacts may cause burns or fire .
4) If used incorrectly, liquid may leak
from the battery. Avoid contact with
this. In the event of accidental contact,
rinse off with water. If the liquid gets into
eyes, seek medical assistance . Leaking battery
fluid may cause skin irritations or burns .
Service
1) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained .
m WARNING!
Wear safety glasses and a dust mask!
Angle grinder warnings
Common safety instructions for grinding
and cutting
1) This electric tool is to be used as a
grinder and cutting grinder. Follow
all safety instructions, directives,
illustrations and facts which you
receive with the device. If you do not
follow these instructions, an electrical shock,
fire and/or serious injury may occur .
2) This electric tool is not suitable
for sanding, wire brushing and
polishing. Operations for which the power
tool was not designed may create a hazard
and cause personal injury .
3) Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer. Just because the accessory
can be attached to your power tool, it does not
assure safe operation .