Publicité
Les langues disponibles
Les langues disponibles
˜ First set-up of the product
˜ Unpacking the product and
basic cleaning
1 . Take the product out of the packaging and
remove all packaging materials and plastic
wrappings .
2 . Check to make sure that all listed parts are
included (see "Scope of delivery") .
3 . Check whether the product and all parts are
in good condition, if any damage or defect is
detected, do not use the product, but follow the
procedure described in chapter "Warranty" .
˜ Mounting the product
CAUTION! RISK OF INJURY!
m
Ensure that you have sufficient space
u
in which to work, and that you do not
endanger other people .
Setting the protective hood
m
CAUTION!
The product must only be operated with the
u
protective hood
1 ]
[
NOTE
Adjust the protective hood such that any
u
sparks or detached parts cannot hit either
the user or any bystanders .
The protective hood must also be positioned
u
such that the sparks cannot ignite
combustible parts, including those in the
surroundings .
1 . Press the battery release buttons
the battery
out of the product .
9 ]
[
2 . Turn the protective hood
position . The closed side of the protective hood
must always face the operator .
Installing/changing the cutting/grinding
disc
m
CAUTION!
Before initial operation, check the tightness
u
of the clamping screw
38 GB/IE
mounted .
and pull
8 ]
[
into the working
1 ]
[
.
3 ]
[
NOTE
If the direction of rotation is marked on
u
your cutting/grinding disc, make sure that it
matches the direction of rotation mark on the
product .
NOTES ON REPLACEMENT
Never operate the product without protective
u
equipment .
Ensure that the rotation speed stated on the
u
cutting/grinding disc is the same or higher
than the nominal rotation speed of the
product .
Ensure that the cutting/grinding disc
u
dimensions match those of the product .
Only use flawless discs (ringing test: when
u
you strike the grinding disc with a plastic
hammer, it results in a clear sound) .
Never re-drill a locating hole which is too
u
small to make it larger .
Never use separate bushings or adapters in
u
order to make grinding discs with a hole that
is too large fit the product .
Do not use any saw blades .
u
To clamp the grinding tools only use the
u
clamping flange provided .
The clamping screw
u
tight in order to avoid breaking the cutting/
grinding disc .
1 . Press and hold the spindle retaining tab
2 . Loosen the clamping screw
key
. Release the spindle retaining tab .
11 ]
[
3 . Position the desired cutting/grinding disc
on the mounting flange
cutting/grinding disc should always face the
product .
4 . Reposition the clamping flange
of the clamping flange with recess generally
points to the attachment tool and thus to the
cutting/grinding disc .
The side with the marking on the clamping
flange
must be visible .
must not be too
3 ]
[
.
4 ]
[
with the hex
3 ]
[
2 ]
[
. The label on the
[
12 ]
. The side
13 ]
[
Publicité
