Parkside PWSA 12 C2 Mode D'emploi page 37

Cleaning and user maintenance shall not be
made by children without supervision .
Do not charge non-rechargeable batteries .
Disregarding this instruction is hazardous .
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard .
Protect the electrical parts against moisture . Do
not immerse such parts in water or other liquids
to avoid electrical shock . Never hold the
appliance under running water . Pay attention
to the instructions provided for cleaning,
maintenance and repair .
The appliance is suitable for indoor use only .
m ATTENTION! This charger is only designed
for charging the battery pack types:
Parkside 12 V battery pack
PAPK 12 A4 2 Ah
PAPK 12 B4 4 Ah
Customers can obtain compatible replacement
batteries and chargers from the LIDL online
shop www .lidl .de .
Practical tips
Cutting disc:
m WARNING!
Never use a scrubbing wheel for cutting!
u
Only certified, fibre-reinforced cutting or
o
grinding discs may be used .
In general, work with small scrubs . Exert only
o
moderate pressure on the workpiece .
Always work in the counter-direction . This
o
ensures that the device is not pushed out of the
cut through lack of control .
Cutting of stone materials:
NOTE
u
It is best to use a diamond cutting disc to cut
o
stone materials . Make sure in any case that
the cutting disc is suitable and labelled for our
application .
When cutting stone materials, ensure that there
o
is sufficient dust extraction .
Wear a dust protection mask .
o
The device may only be used for dry cutting/
o
dry grinding .
3 cells
Scrubbing wheels:
6 cells
m
u
NOTE
u
u
Replacement parts/accessories:
Spare parts and accessories such as cutting discs
can be obtained through your authorized dealer .
When buying always consider the technical
requirements of this product (see "Technical data") .
If you are not certain, ask a qualified specialist and
get advice from your trusted dealer . If you are not
sure where to purchase, please contact the Lidl
service hotline .
Slits in structural walls are subject to the
standard DIN 1053 Part 1 or country-
specific regulations . These regulations must
be observed without fail . Before beginning
work you should ask the structural engineer,
architect or relevant construction supervisor
for advice .
WARNING!
Never use a cutting wheel for scrubbing!
Exert only moderate pressure on the
workpiece . Move the product evenly back
and forth .
A working angle of 30° to 40° achieves the
best results for scrub grinding .
GB/IE 37