ARIETE Pane Express metal 130 Mode D'emploi page 19

2 Establish the delay time by pressing the "
preselected menu. For example, it is 8.30pm and you want the bread ready for 7.00am the following
day; the delay time will therefore be 10 hours and 30 minutes. Therefore, press the "
the "10.30" appears on the display. Each push of the key increases the time by 10 minutes.
3 Press the " " key to activate the delay programme. Two points will be seen that flash and the
display will start the countdown and display the time remaining. Please note that the maximum
delay time is 13 hours. Do not use perishable ingredients, such as eggs, fresh milk, fruit and
onions when operating the delay menu.
" " key
Press the key once: the light comes on for the cycles to be observed. Pressing the key again within
1 minute, the light goes out. After 1 minute, the light goes out on its own.
" " key
Once the cycle has started, press the "
machine will stop, but the selection and adjustment will remain in the memory and the time remaining
will appear on the display. Pressing the "
Keeping the bread hot
After it has baked, the bread can be kept hot for 60 minutes. To extract the bread, switch off the
programme using the "
Power cut
If there is a power cut that lasts less than 10 minutes, the programme will continue as soon as the
electricity returns. The programme time will be extended for as long as the time of the power cut. If the
power cut lasts more than 10 minutes, the programme will stop. If this happens, disconnect the appli- -
ance, let it cool down, empty the bread pan, remove the ingredients, clean and switch on again. If the
dough has not reached the raising phase when the electrical current is less, it is possible to press the "
" key to restart the programme.
ATTENTION: Do not scratch the non-stick surfaces of the bread pan (E) and the kneading arm (F).
Room temperature
The machine functions at various temperatures, but there is a difference in the dimensions of the
bread depending on whether the ambience is hot or cold. An ambient temperature of between 15°C
and 34°C is recommended.
Alarm indications
If "H HH" appears on the display after the programme has started, the temperature inside is too
high and it will be necessary to stop the programme. Open the lid and let the machine cool down for
10/20 minutes.
After having pressed the "
sensor is not functioning and needs to be checked by an authorized technician.
All manuals and user guides at all-guides.com
" key on the control panel (L).
" key, if "E E0" or "E E1" appears on the display, the temperature
" key. The delay time must include the cycle time of the
" key to stop it. Depending on the requirements, the
" key again, the programme restarts.
- 17 -
EN
" key until