HOLZMANN MASCHINEN HOB410ECO Mode D'emploi page 43

16.10 Storage
Store the machine in a dry, frost-proof and lockable place when not in use. Disconnect the
machine from the power supply. Make sure that unauthorised persons and especially children do
not have access to the machine.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil (e.g.
WD40 rust inhibitor).
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
16.11 Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
Many possible sources of error can be excluded in advance if the machine is properly connected to
the power supply. If you are unable to carry out necessary repairs properly and/or do not have the
required training, always consult a specialist to correct the problem.
Problem
Machine does not start or shuts
down automatically during idling
Machine stops during operation
Machine vibrates during
operation
Workpiece clamps during
thicknessing
Bad surface condition after
operating
Rough surface after operating
Cracked surface after operating
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T E
W A R N I N G
Possible cause
 Power supply outage
 Damaged or incorrect
connected extension cable
 Damaged switch or motor
 Blunt blade
 Feeding speed to high
 Motor protection triggered
 Wrong adjusted blade
 Ground not flat or base feet
wrong adjusted
 Cutting depth to high
 Dirty thicknessing table
 Blunt blade
 Uneven feed of the workpiece
 Workpiece too moist
 Workpiece was processed
against the direction of growth
 Cutting depth to high
TROUBLESHOOTING
Solution
Check fuse of the power

supply
Check plug or extension

cable
Contact customer support

Check blade

Work with lower feeding

speed
Let the motor cool down

Check the setting of the

blades
Set the base feet correct

Set the correct cutting

depth and operate in more
steps
Clean and apply the table

surface with lubricant
Check blade

Feed workpiece evenly and

with constant pressure
Use drier workpiece

Proceed the workpiece in

opposite direction
Set the correct cutting

depth and operate in more
steps
HOB410ECO_400V | HOB410ECOSMW2_400V
43