Publicité
Les langues disponibles
Les langues disponibles
15.6.3
Planing short workpieces
15.6.4 Planing the workpiece with small cross section
15.7
Thicknessing
It is necessary to modify/adjust the machine before using as a thicknesser.
Long, protruding workpieces must be sufficiently supported! Use suitable aids such as roller
•
blocks etc. for this purpose. If you do not follow these instructions, there is a danger of the
workpiece being raised up quickly and/or the machine being tilted!
•
Use the thicknessing function only to reduce the thickness of a workpiece with an already
surface planed facing!
For workpieces with a difference in thickness, the chip removal must be measured at the
•
maximum thickness and the workpiece machined with this side first.
Make sure that the workpiece to be machined is free of foreign objects and/or knots in
•
order to avoid dangerous fractures.
Only plane workpieces that rest firmly on the machine and can be guided safely!
•
If several workpieces are to be processed in series, all pieces of the same thickness should
•
be run through in succession without changing the setting.
Perform the machining process from the beginning until the desired thickness is achieved.
•
15.7.1
Converting from planer to thicknessing
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• When planing short workpieces, a sliding wood or similar
device should be used!
• Adjust planer fence and blade guard to the size of the
sliding wood.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
• After use, the sliding wood must be reattached on his place
on the side of the machine.
• When planing workpieces with a small cross-section, an
additional wood angle must be mounted!
• Fasten the wood angle to the planer fence as shown using
lever clamps.
• When planing, place the workpiece on the planer table and
press it against the additional wood angle and planer table.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
N O T E
• Slide the planer fence (1) and the planer knife cover
(3) all the way to the back.
• Disassemble the hose of the dust collector plug (2).
• Unlock the fixation handles planer tables (4) of the
planer tables. Therefore pull out and turn the handle
• Unfold the planer tables (5) completely and ensure
that the lock (6) engages completely
• Turn down the dust collector hood (7).
• Mount hose to the dust collector plug (8).
Proceed in reverse order to readjust to the planer
mode.
OPERATION
HOB410ECO_400V | HOB410ECOSMW2_400V
38
Publicité
