HOLZMANN MASCHINEN HOB410ECO Mode D'emploi page 36

The alignment of the planer fence at right angles should be checked again
before initial operation and readjusted if necessary to achieve an exact
planing result.
15.4 Operation
15.4.1 Switch the machine on and off
15.4.2 Activating/Deactivating the thicknesser feed rate
15.5 Dust collection plug
Do not operate the machine without the dust collection system connected to it and switched on.
The dimensions of the dust collection plug can be found in the technical data.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• The angle is measured with a protractor (8). This is placed on the planer
table and applied to the planer fence.
• If it is not possible to place the protractor completely against the planer
fence, the planer fence is not set exactly at right angles and an
adjustment of the scale (10) is necessary.
Switch on
Press the switch-on button (I).
Switch off
Press the switch-off (0) or in emergency situations the
emergency-stop button (3)
CAUTION: The emergency stop button can only be unlocked after
the emergency situation has been eliminated.
Activate feed (+):
Swivel the lever for thicknesser feeder (1) upwards.
Feed is activated
Deactivated feed (-):
Swivel the lever for thicknesser feeder (1) downwards.
Feed is deactivated.
Planer:
The extraction connection (1) is under the planer tables (exit
planer table)
Thicknesser:
After the conversion to thicknessing, fold down the dust
colletor hood (2).
OPERATION
HOB410ECO_400V | HOB410ECOSMW2_400V
36