Publicité
Les langues disponibles
Les langues disponibles
For readjusting to planer mode please lower the thicknesser table to lowest position
to avoid any damages.
15.7.2
Thicknessing of workpieces
working direction
In the case of resin residues on the wood, it may be advisable to apply a thin
•
layer of a special lubricant to the machine table in order to ensure that the
workpiece slides evenly through the thickness planer.
•
If the workpiece is no longer moved by the automatic feed, pull out the
workpiece manually.
•
After operation switch off the machine and set the lever for thicknesser feeder
to position "OFF".
•
Before further activities wait until blade shaft is at a standstill!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Lock dust collector hood:
Pull out the lock pin (9) before turning back the dust
•
collector hood
Lock planer tables:
•
Lift the lock (6) on before closing the planer tables
N O T E
• Unlock the locking lever height adjustment thicknesser (1) and
set the required height of the thicknessing table with the
handwheel (2).
• The height will be shown on the scale (3) and counter block (3).
• Set the thicknessing table height to the workpiece height
minus the requested cutting depth.
• Maximum cutting depth refer to the technical data!
NOTE:
At the beginning of the thicknessing process, the
workpieces may still have very different thicknesses - this must
be taken into account in the set cutting depth in order not to
overload the machine.
• Fix the thicknessing table height with the locking lever height
adjustment.
• Switch on the machine.
• Put the lever for thicknesser feeder (4) to the upper position to
start the feed.
• Insert workpiece so that the surface to be machined facing
upwards and push forward
• The workpiece is pulled through of the automatic feed
• As soon as the half of the workpiece has been processed
change to the opposite operator side of the machine and take
on the finished workpiece.
• After operation switch off the machine.
• Before further activities wait until blade shaft is at a standstill!
N O T E
OPERATION
HOB410ECO_400V | HOB410ECOSMW2_400V
39
Publicité
