Publicité
Les langues disponibles
Les langues disponibles
Never start the machine with a workpiece pressed down!
•
Long workpieces must be supported
•
Property damage and injury by bouncing up the workpiece or tilting of the
•
machine possible!
15.2
Initial check before start
Check that all guards are installed.
•
Check whether suitable planing knives have been correctly assembled.
•
Check whether the connection to a dust collection system is available.
•
Check that the planer shafts rotate in the correct direction.
•
15.3
Settings
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
CAUTION
1.
Height adjustment of the planing tables
Entry planer table
The cutting depth is set with the adjustment lever
planer cutting depth (1)
Check scale knife entry planer table = 0
If necessary, adjust the arrow of the scale (2)
2.
Setting infeed / oufeed roller
The pressure force of the spring-mounted infeed and
outfeed roller is factory-set.
If it is necessary to change the pressure force, it can
be adjusted with the screws (3 and 4).
3.
Setting arm and planer knife cover
Height
• Set the desired height with adjusting screw (5)
Planer knife cover
• Loosen the clamping screw (6)
• The planer knife cover can be moved and
adapted to the size of the workpiece
• Relock the clamping screw (6) when the desired
position is reached.
4.
Setting planer fence
• Unlock the lock lever (7)
• Set planer fence to the desired angle position
• Relock the lock lever (7) when the desired
position is reached
• Loosen the clamping levers (9)
• Adapt the planer fence to the workpiece width
• Relock the clamping levers
OPERATION
HOB410ECO_400V | HOB410ECOSMW2_400V
35
Publicité
