Publicité
Les langues disponibles
Les langues disponibles
14.2
Requirements for the place of installation
Choose a suitable place for the machine. Pay attention to the safety requirements and the
dimensions of the machine. The selected location must ensure a suitable connection to the power
supply as well as the possibility of connection to an extraction system. Make sure that the floor can
support the load of the machine. The machine must be levelled simultaneously at all support
points. It is also necessary to guarantee a distance of at least 0.8 m around the machine. In front of
and behind the machine, the necessary distance must be provided for the feeding of long
workpieces.
14.3
Preparation of the surface
The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners will result
in damage to the surface! Therefore use only mild cleaning agents.
Before you install and commission the machine at the intended location, carefully remove the
anti-corrosion protection and grease residues. This can be done with the usual solvents. Under no
circumstances should you use nitro thinner or other cleaning agents that could attack the
machine's paint.
14.4 Assembling the machine
The machine is pre-assembled. The parts that have been disassembled for transport must be
assembled before use. Follow the instructions below:
The machine and machine components are heavy!
2 persons are required to assemble the machine.
Handling the machine with the power supply intact can result in serious injury or
death. Therefore, do not connect the machine to the power supply before
completing the assembly.
14.5
Electrical connection
Dangerous electrical voltage!
The machine may only be connected to the power supply and the associated
checks carried out by a qualified electrician or under the instruction and
supervision of a qualified electrician!
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T E
N O T E
W A R N I N G
1.
Assembly planer knife cover
Insert planer knife cover (1) into the holder (2) and
•
fix it in desired position with the fixing knop (3)
WARNING
ASSEMBLY
HOB410ECO_400V | HOB410ECOSMW2_400V
33
Publicité
