Publicité
Les langues disponibles
Les langues disponibles
Danger from cutting edges! Always wear protective gloves when working on the
planing shaft! Injuries to hands due to sharp cutting edges
16.9
Replacing/turning the cutter insert (HOB410ECOSMW2)
The spiral cutter head is suitable for cutter inserts.
If the planing surface is bad, only the damaged or blunt cutter insert needs to be
replaced/turned.
The appropriate dimensions can be found in the technical data.
Danger from cutting edges! Always wear protective gloves when working on the
spiral cutter
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
1.
Adjust the machine to thickness planing mode
2. The dust collection hood must be open in order to have access
to the shaft
3. Loosen the gib screws (1)
4. The planing kife (3) will be pushed up by the pressure springs
(5)
5. Remove the gib (2) and the planing knife (3)
6. Clean the planer shaft (4) and gibs (2)
7. Replace sharpend/new planning knife (3) and gib (2)
8. Slightly tighten the gib screws (1) and and perform the
adjustment procedure.
9. Place the setting gauge (6: optional accessories: MEL2;
7: setting gauge of delivery content) on the planning shaft and
adjust the correct height.
10. Tighten the gib screws (1) to fix the gib (2) (recommended
minimium tightening torque 20Nm)
11. Do not use planning knives with a height of less than 19mm
due to the too small clamping surface
12. Repeat procedure for all planing knives.
N O T E
W A R N I N G
head! Injuries to hands due to sharp cutting edges
1.
Adjust the machine to thickness planing mode
2.
The dust collection hood must be open in order to have
access to the spiral cutter head (1)
3.
Remove wood chips and dust from the heads of the screws
for cutter inserts (2)
4.
Unscrew the screw for cutter inserts with the key for inserts
(3)
5.
Remove the cutter insert (4)
6.
Thoroughly clean the place of the cutter insert on the spiral
cutter head
7.
If the cutter insert will be turned, clean it thoroughly as well
NOTE:
A cutter insert can be turned 3 times
8.
Now renew the cutter insert, or turn it over to the next
position
NOTE:
As an aid, it is advisable to always insert a new cutter
insert with the starting point (6) at the same position
9.
Fix the cutter insert with the screw for cutter inserts.
(Recommended minimum tightening torque 4Nm)
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOB410ECO_400V | HOB410ECOSMW2_400V
42
Publicité
