Emerson AVENTICS XV03 Notice D'instruction page 19

10.2 Preparation
Implement safety measures. See
u
Tools
• 1x hex key (size 2)
• 1x Torx 5 screwdriver
• 1x Torx 10 screwdriver
• 1x screwdriver PZ1
• For screw connections with a thread size of 1/8" for hoses with a diameter of
8 mm:
1x hexagon socket wrench H6 with length A > 14 mm, if B = 6.35 mm (1/4"),
see g Fig. 5
Fig. 5: Hexagon socket wrench H6
10.3 Procedure
Disassembly is performed in reverse order to assembly. See
installation.
11 Conversion and extension
11.1 Planning
11.1.1 Conditions
For extension and conversion, observe the same requirements as for assembly.
See g 6. Assembly and installation.
Product-specific requirements
• Depending on the configuration, accessories can be retrofitted. See
cessories. Observe the documentation of the accessories.
• To identify the accessories: see accessories name plate.
• Retrofit a maximum of 2 intermediate plates.
• The product contains sensitive electronics.
Recommendation: Handle product with great care.
11.1.2 Required material and tools
Product Tools
Separator for channel X Hexagon socket max. H1.5
Hexagon socket H2
Separator for channel 1, Hexagon socket max. H4
3 or 5
XV03 Hexagon socket H2
XV05 Hexagon socket H2.5 Integrated
Blanking plate / supply Torx 5 screwdriver
plate
Sandwich plate, air sup- Slotted screwdriver, max. S3.2,
ply / sandwich plate, ex- 1.0 thickness
haust
11.2 Preparation
11.2.1 Implementing safety measures
Procedure
1. Do not carry out any work on the system during preparation.
2. Close off dangerous areas.
AVENTICS™ XV03 / XV05 | 570365-BAL-AA | English
g 11.2.1 Implementing safety measures.
g 6. Assembly and
Screws Tightening
torque
- -
Integrated 0.3 Nm
- -
Integrated 0.3 Nm
0.3 Nm
Torx 0.25 ±0.05 Nm
Slot XV03
XV05
3. Make sure the system or system part is not under pressure or voltage.
4. Protect the system against being restarted.
5. Allow product and adjacent system parts to cool down.
6. Wear PPE.
11.3 Retrofitting separators
Mounting separator in channel 1, 3, or 5
Fig. 6: Mounting separator in channel 1, 3, or 5
1. Insert screwdriver from above in the hole on the channel at the desired posi-
tion.
2. Insert separator with screw last in the same channel.
3. Tighten separator with the second screwdriver.
Tightening torque: 0.3 Nm
Mounting separator in channel X
g 16. Ac-
9 0
°
0.2 Nm
0.6 Nm
Fig. 7: Mounting separator in channel X
9 0
°
19