Publicité
Les langues disponibles
Les langues disponibles
Before Use
EN
1. Place the Base Station and Connect to an Electrical Outlet
Place the base station in a location that is as open as possible with a good
Wi-Fi signal. Remove any objects that are closer than 1.5 m from the front and
5 cm from either side of the base station. Insert the power cord into the base
station and plug it into the socket.
＞5 cm
＞5 cm
＞1.5 m
I : ON
O : OFF
Firmly insert the power cord
upwards until the indicator turns
on.
Note:
· Make sure that no objects might block the signaling area.
· To prevent water stains from wetting wood floors or carpets, placing the
base station on tile floors or marble floors is recommended.
10
2. Remove the Protection of Washboard and Install the Ramp
Extension Plate
Remove the protection of washboard, and then put the washboard back
into the base station downwards in an inclined way. Then install the ramp
extension plate down to the base station.
3. Remove Robot Protections and Install the Side Brush and Mop
Assembly
④
②
Side Brush
Clip
①
③
Note: Install the side brush until it clicks into place.
Before Use
4. Connect the Robot to the Base Station
Press and hold the button
on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward
the washboard. Then you will hear a voice notification when the robot
successfully connects to the base station.
Note: It is recommended to fully charge the robot before its first use. When
the robot cannot be turned on after the battery is depleted, manually connect
the robot with the station to charge it.
5. Add the Cleaning Solution
(1) Remove the dust tank cover and pull out the auto-detergent compartment.
(2) Open the upper lid of the compartment and add the cleaning solution.
(3) Close the lid of the compartment, put it back into the base station, and
then reinstall the dust tank cover. The cleaning solution will be added
automatically while working.
Note:
·
The auto-detergent compartment can be filled up with cleaning solution
for use. Do not add any liquid other than the officially-approved cleaning
solution to help prevent malfunction.
·
Install the auto-detergent compartment until it clicks into place.
6. Add Water to the Clean Water Tank
Take out the clean water tank from the base station and fill up the tank with
clean water. Then install it back into the base station.
Note: Do not add hot water into the water tank, as this may cause the tank to
become deformed.
EN
11
Publicité
