Dreame DreameBot X30 Ultra Manuel D'utilisation page 13

Routine Maintenance
EN
Side Brush & Mop Pad Holder
Remove and clean the side brush and mop pad holder.
Omnidirectional Wheel
Note:
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back
after drying it completely.
20
Dust Box and Filter
1. Open the robot cover and press the dust box clip to remove the dust box.
2. Open the dust box cover, remove the filter, and then empty the dust box as
shown in the diagram.
Routine Maintenance
3. Gently tap the basket of the filter to remove the dirt.
Note: Do not attempt to clean the filter with a brush, a finger or sharp objects
to prevent damage.
4. Rinse the dust box and filter with water and dry them completely before
reinstalling.
Note:
· Rinse the dust box and filter with clean water only. Do not use any detergent.
· Use the dust box and filter only when they are completely dry.
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft and dry cloth,
as shown in the below figure:
AI Visual Sensor
Line Laser Sensors
Laser Distance
Sensor (LDS)
LED Auxiliary Lights
Edge Sensor
Bumper
Charging Contacts
Cliff Sensors
24h
Note: A wet cloth can damage sensitive elements within the robot and the
base station. Please use a dry cloth for cleaning.
EN
Carpet Sensor
21