Cleaning; Maintenance And Service; Warranty / Guarantee / Liability - Soehnle Professional 7752 Mode D'emploi

3. General information
netic influences, e.g. when operating a radio or mobile phone in the immediate
vicinity of the device, the display value may be affected. At the end of the dis-
turbance, the product can be used again as intended; if necessary, it must be
switched back on.

3.5 Cleaning

Always disconnect the scale from the power supply before cleaning. The unit may
only be cleaned with a damp cloth. Under no circumstances may water infiltrate the
device. Disinfectant may only be used on the membrane keypad of the display.
The following disinfectants are permitted:
methylated spirits; isopropanol; 2% cohrsoline; 1% aqueous Sokrena solution; 5%
sagrotan; 5% gigasept.
Spraying of the device and the connector is not permitted.

3.6 Maintenance and service

The metrological check was carried out during manufacture by initial verification.
was carried out. Further regular metrological checks (recalibration) must be carri-
ed out by the competent calibration authorities in accordance with the relevant
national regulations.
This scale may only be opened and repaired by trained service partners authorised
by Soehnle Industrial Solutions. If the scale is not working as intended, there is a
suspicion of damage. It is imperative that the scale is returned to a service partner
authorized by Soehnle Industrial Solutions. In case of repair by an authorized ser-
vice partner, only original spare parts may be used. The original parts are described
in the service documentation with order number.

3.7 Warranty / Guarantee / Liability

32