Publicité
Les langues disponibles
Les langues disponibles
How to Use
9. Use the Mopping Function
It is recommended that all floors are vacuumed at least three
times before the first mopping session to achieve a better
cleaning effect.
1) Dampen the mop pad, wring out excess water, and stick
them onto the mop pad holder firmly. Then install the mopping
module on the robot.
2) Remove the water tank and fill it with water as shown in the
figure, then put it back into place.
Note:
· Do not fill with hot water, which may cause distortion of the water tank.
· Do not expose the tank to the sun directly.
· If slow water flow occurs, or the outflow is not well-distributed, please clean the
air hole in the tank.
3) Press the button
or use the app to start cleaning.
Note:
· It is not recommended to use the mopping function on carpets.
· Use the app to adjust the water flow as required.
4) After cleaning task is done, remove the mop pad as shown
in the diagram. To remove the water tank, press and hold the
release clip on both sides, and drag them upward.
Note: When the robot is charging or not in use, remove the mopping module, pour
out all the remaining water in the tank, and clean the mop pad to prevent mildew
or odor.
EN
13
Publicité
