Publicité
Les langues disponibles
Les langues disponibles
Preparation Before Use
1. Remove the protective strips
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
3. Set up the charging dock
Peel o the double-sided tape at the bottom of the charging
dock, then place the dock on the level ground against the wall
and connect it to a power outlet.
＞ 0 5 m
Note:
· Keep the immediate area 1.5m in front of the charger and 0.5m to both sides of the
charging dock clear of objects.
· To ensure you can connect to the robot with your phone well, make sure the robot
and charging dock are within WiFi range.
· Do not place the charging dock in an area with direct sunlight or where other
objects might block the signal, as this may hinder the robot from returning to the
charging dock.
· Please clean the floor area where the charging dock will be placed with a dry rag.
· Use of the double-sided tape is based on your need.
· If necessary, remove the double-sided tape slowly to reduce adhesive residue.
4. Place the robot onto the charging dock to charge
Note:
·
mm
·
m
m
m
m
＞ 0 5 m
＞ 1 5 m
Battery Level Indicator
• White: Battery level is more than 15%
• Orange: Battery level is less than 15%
m
EN
9
Publicité
