Publicité
Les langues disponibles
Les langues disponibles
-
Do not operate the grinder if there is no food or if the food tray is not secured
in place.
-
To avoid personal injuries when feeding the meat into the appliance, only use
the pusher supplied with the grinder. Do not feed the meat with your hands.
is running.
-
Tie back loose hair and clothing, and roll up long sleeves; and remove ties,
rings, watches, bracelets, or other jewelry before operating the grinder.
-
Never remove any parts while the meat grinder is running.
-
Always disassemble the meat grinder and cover the meat grinder outlet with
the meat grinder outlet cover on the mixer head after each use.
-
Do not grind hard foods such as bones, nuts and frozen meats to avoid
jamming.
-
CAUTION: Blades are sharp. Handle with care both in use and
when cleaning.
1.
Insert the feed screw into the feeding container, with the shaft end outside, by
turning the screw slightly until it is set into the slot of the feeding container.
(Fig. 1)
2.
Place cutting blade onto the feed screw shaft with the sharp blade facing
the front.
Note: The cutting surface should be faced to cutting plate when being set,
otherwise meat will not be grinding.
(Fig. 1)
Note:
properly, meat may be leaked out around the outlet on the mixer head.
4.
Tighten the feeding container nut. (Fig. 1)
5.
Remove the meat grinder outlet cover. (Fig. 2)
6.
Press the release button for meat grinder then insert the feeding container
onto the meat grinder outlet and turn anticlockwise to lock it in place. (Fig. 3)
7.
Place the food tray and the pusher on top of the funnel of the feeding
8.
Place a bowl or dish under the feeding container to catch the food.
9.
Insert the power plug into the mains supply outlet.
to leave the feed chute area open.
11. Turn the speed control to position 1-3 to start the operation. Gradually push
the meat pieces into the funnel using the pusher. Do not push too hard or too
much meat into the funnel.
Note: Always use the food pusher to feed foods into the feeding container.
12. After use, turn the speed control to "0", and then unplug the appliance
Note: Do not operate the appliance for longer than 5 minutes each time.
Let the main unit rest for few minutes. Do not work continuously for more
than 15 minutes. After continuous operation, let the appliance cool down
thoroughly then resume.
Caution of Jamming
To avoid jamming, do not force operate the appliance with excessive pressure.
If the operation slows down or meat does not come out from the cutting plate, it
means that probably some pieces of meat are stuck in the grinder, follow steps
below to release it:
1.
Switch the appliance off and wait until the motor has stopped completely.
2.
Unplug and disassemble parts to remove ingredients in the feeding container
and blades.
3.
Attach the parts again and continue grinding meat.
14
Publicité
