Publicité
Les langues disponibles
Les langues disponibles
mela (olela
Information
Precautions
Troubleshooting Guide
Maintenance
Specifications
Index to Parts and Controls
Index
be SGT
cae
Nie aoe AL
ee
Precautions
If you have any questions or problems
concerning your stereo system, please
consult your nearest Sony dealer.
On operating voltage
Before operating the stereo system, check'
that the operating voltage of your stereo
system is identical with the voltage of your
local power supply.
Operating voltage
220-230 V AC, 50/
60 Hz
On safety
¢ The stereo system is not disconnected from
the AC power source (mains) as long as it
is connected to the wall outlet, even if the
system itself has been turned off.
« Unplug the system from the wall outlet
(mains) if it is not to be used for an
extended period of time. To disconnect
the cord (mains lead), pull it out by the
plug. Do not pull the cord itself.
* Should any solid object or liquid fall into a
component, unplug the stereo system and
have the component checked by qualified
personnel before operating it any further.
¢ Should the AC power cord (mains lead)
need to be changed, have it done ata
qualified service shop only.
¢ As the laser beam used in this unit is
harmful to the eyes, do not attempt to
disassemble the cabinet. Refer servicing to
qualified personnel only.
On installation
Place the stereo system in a location with
adequate ventilation to prevent heat build-
up in the stereo system.
On condensation in the CD player
component
If the system is brought directly from a cold
to a warm one, or is placed in a very damp
room, moisture may condense on the lens
inside any CD players. Should this occur,
the CD player will not operate. Remove any
CDs and leave the system turned on for
about an hour until the moisture evaporates.
To save a tape permanently
To prevent a tape from being accidentally
recorded over, break off the cassette safety
tab from side A or B as illustrated. If you
later want to reuse the tape for recording,
cover the broken tab with adhesive tape.
[5
\
em=16
es
:
)
©)
When you are using a type II (CrO2)
cassette, be careful not to cover the detector
slots which allow the tape player to
automatically detect the type of tape.
TYPE Il
od
7
ae
ec190
Detector slots
In case colour irregularity is
observed on nearby TV screen
With the magnetically shielded type of
speaker system, the speakers can be
installed near a TV set. However, colour
irregularity may still be observed on the
TV screen depending on the type of your
TV set.
If colour irregularity is observed...
Turn off the TV set once, then turn it on
after 15 to 30 minutes.
If colour irregularity is observed
again...
Place the speakers farther away from the
TV set.
fi
27
[sree a ioe na ewe
ae ae Ae Nn
|
Troubleshooting
Guide
If you run into any problem using this
stereo system, use the following check list.
First check the following points.
« The mains lead is connected firmly.
¢ The speakers are connected correctly and
firmly.
Should any problem persist after you have
made the checks below, consult your
nearest Sony dealer.
Tuner
"TUNED" flashes in the display.
> Adjust the aerial.
"STEREO" flashes in the display.
~> Adjust the aerial.
Severe hum or noise
> Adjust the aerial.
> The signal strength is too weak.
Connect the external aerial.
-> Connect the ground wire.
A stereo FM programme cannot be
received in stereo.
> Press STEREO/ MONO so that
"STEREO" appears.
continue to next page >
For Your Information
Publicité
