Publicité
Les langues disponibles
Les langues disponibles
8 Press REC.
The REC and 1 (pause) lamps light up
and deck B stands by for recording.
The E> lamp lights up and the <d lamp
flashes for a few seconds, then
disappears.
Side in recording
pause mode
If you want to start recording from the
reverse side, press <<] so that the <I
lamp lights steadily.
9 Press 10 to release recording pause.
Recording starts.
10 press CD E>.
The CD player starts playing.
To
Press
Stop recording
QO
Pause recording
a0
To record with the surround effect
Press DSP (SURROUND?") so that "SUR 1
(item) (SUR {item} )" or "SUR 2 fitimn) "
appears in the display.
The equalizer you have adjusted will not be
recorded.
* LBT-N355 only
Note
If you want to record specific tracks of the
CD, the "programme edit" feature will
make it easier.
aS
a
ae
|
Recording a CD:
Selecting Tape
Lenath
(tane select
Sew
SES
LSS
we
edit )
You can have the stereo system select and
indicate the most suitable tape length for
recording each disc automatically.
You cannot use tape select edit for discs
which contain 21 tracks or more.
SYSTEM
POWER°>ON
m OUI
NO
CHECK
1 Press FUNCTION repeatedly until
"CD" appears in the display.
2 Press & OPEN and place a CD on the
tray.
Make sure the disc number in the
playing position in the display is the one
you want to record.
The total number of tracks and the
playing time appear in the display.
3 Press EDIT on the remote.
"TAPE SELECT" appears in the display
and the player divides the selections
automatically.
Then the display changes as follows:
flashing
4 Press & EJECT and insert a blank tape
of the indicated length (or longer) into
deck B with the side you want to record
on fasing forward.
Make sure the tabs on the cassette have
not been removed.
5 Select dual or single-sided recording.
Press DIRECTION
to select
To record
One side of the tape
==
c=) or RELAY
Both sides*
* Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
6 When you want to reduce the hiss noise
in low-level high-frequency signals,
press DOLBY NR so that "DOLBY NR
B" appears in the display.
7 Press CD SYNCHRO.
The REC and 00 (pause) lamps light up
and deck B stands by for recording.
The E> lamp lights up and the <J lamp
flashes for a few seconds, then
disappears.
Ad
a= | og
If you want to start recording from the
reverse side, press <J so that the <1]
lamp lights steadily.
Side in recording
pause mode
8 Press 00 on the tape player to release
recording pause.
Recording starts.
After about 10 seconds, the CD player
starts playing.
To stop recording
Press O on the tape player.
To check the order
Press CHECK on the remote.
To cancel tape select edit
Press CONTINUE on the CD player.
Chapter 4: the Tape Player
Publicité
