Error And Information Messages; Technical Specifications - Futurelight Scan SC - 530 Mode D'emploi

This message appears if you try to switch On the lamp within 5 minutes after having switched it Off (the lamp
is too hot). The message will come at the display if the lamp doesn´t ignite within 20 seconds. The SC-570 will
store this information and automatically ignite the lamp when the 5 minutes period has expired.
Note: The SC-530 switch On the lamp immediately without any delay as there is the halogen 24V/250W.
The ignition of the lamp is seven times unsuccessful (six times were appeared HEAt (message before), on the
display will appear "LAEr", meaning that the lamp could be damaged or even missed, the fixture is overheating
(can be occured if the ambient temperature is 55°C or more) or there could be a failure on the ignitor or ballast.
Please place or replace the lamp, check the ambient temperature or if the situation was not caused by the lamp
please, contact your dealer.
Note: The SC-530 try to switch On the halogen lamp five times with 5 minutes delay between each switching. If
these five switchings are unsuccesful, on the display will appear "LA.Er", meaning that the lamp could be
damaged or even missed, the fixture is overheating (can be occured if the ambient temperature is 55°C or more)
or there could be a failure on the transformer
This error message inform you that the fixture was overheating (occured if the ambient temperature is 55°C or
more) and that the relay switched Off the lamp. This message will shine on the display until the temperature will
be on the suitable level, then on the display will appear the HEAt message meaning the lamp is too hot.
(explanation see above).
This message appears if the lamp lighting sensor is failed. Please, contact your dealer.
This message will appear if the fixture was shortly disconnect from the main.
It will appear if the frequency of the main is not standard 50 or 60Hz.
Power supply
SC-530/SC-570:
Power consumption:
SC-530:
SC-570:
Lamp
SC-530:
SC-570:
Optical System
- Double condensor lens with high efficiency parabolic mirror
Colours
- 11 interchangeable dichroic-filters plus white
- Colour-wheel with variable rotation speed
Gobos
- 9 static gobos plus full circle
- 1 Multicolor-gobo
Strobe
- Strobe effect with variable speed (1 - 7 flashes per second)
Effects
- Special combined dimmer unit wheel with frost filter, color temperature filters 3200°K and 5600°K
Prisma
- 3 facet prism rotating in both dirrections at different speeds

8. Error and Information messages

9. Technical Specifications

230V/50 Hz
300 W, Fuse: T1,6A
400 W, Fuse: T3,15A
24V/250W
MSD 200W or MSD 250W
3 0